1.5mm x 15mm x 4mm x 50mm AlTiSin Coated Carbide 4 Flute Square End Mill 2pcs 5x7x10mm heat-resistant and wear-resistant

heat-resistant and wear-resistant

* Thread pitch: 1

1 Pack x Brass Tube(2

54mm Pitch Right Angle Female 40 Pins PCB Header Connector Single Row

Lens Type: 5mm Round Top

1.5mm x 15mm x 4mm x 50mm AlTiSin Coated Carbide 4 Flute Square End Mill 2pcs 5x7x10mm heat-resistant and wear-resistantMade of super fine grain carbide, the end mill cutter has high hardness (HRC92), high strength, and wear resistance. With good milling and cutting performance, carbide can run at higher speed than high speed steel. Features square end cut, 4 flute design, large and spiral chip space design for fast and clean chip removal. Sharp cutting edge provides smooth cutting. The AlTiSin composite coating has high hardness, high wear resistance and high thermal